You can use a Rehoming configuration job to move a Skylight sensor: module from one Skylight sensor: control to another.
To set up a Rehoming Job
-
Access the page Commission â–¶ Jobs.
-
Click the Add
button to add a new configuration job. -
Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".
-
Select Rehoming in the left pane. The Rehoming tab is displayed.
-
Choose Migrate unlinked option.
-
Click the Name field, then click
to display the Select Name dialog. -
Select a Skylight sensor: control destination and click OK.
-
Click Apply, then click Close.
-
Click the Refresh
button to refresh the user interface.
Rehoming tab (Commission â–¶ Jobs)
Configuration
| Parameter | Description |
|---|---|
| Migrate unlinked | Indicates whether or not settings have migrated to destination Skylight sensor: control. Possible values:
|
Sensor control destination
| Parameter | Description |
|---|---|
| Name | Identifiers for the devices available for selection. |
| Label | User-defined label that will allow users to identify and group modules. |
| Serial | The serial number of the device. This value is obtained from the Skylight device. |
| IP address | The IP address of the device. |
| Version | The current firmware version that runs the device. |
© 2025 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks