Setting Up an SNMP Agent Configuration Job
  • 21 Jun 2024
  • 2 Minutes to read
  • Contributors
  • PDF

Setting Up an SNMP Agent Configuration Job

  • PDF

Article summary

You can use configuration jobs to set up managed element side of the SNMP connection between managed elements and Skylight orchestrator.

Skylight orchestrator must also be configured to receive SNMP messages from the elements that it manages. For an overview of how Skylight orchestrator manages alarm messaging by SNMP, see "Configuring Alarm Handling via SNMP".

Configuration Steps

Two configuration steps related to SNMP are available in the Configuration Job page:

  • SNMP agent - Enables an SNMP agent on a managed element. The SNMP agent will allow an element to send SNMP trap messages related to alarms and other events to Skylight orchestrator (and other systems if necessary). This section explains how to complete the SNMP agent step. See "Procedure for Setting Up the SNMP Agent" below.

  • SNMP trap receiver - Sets up the connection to the system(s) that will receive SNMP trap messages from the elements. By default, Skylight orchestrator is a trap receiver for all managed elements. See "Using Skylight orchestrator as Default SNMP Receiver for All Elements". However, if your organization has specific requirements, you can set up a configuration job to set up a trap receiver for managed elements. See "Setting Up an SNMP Trap Configuration Job".

Procedure for Setting Up the SNMP Agent

To set up an SNMP agent configuration job

  1. Access the page Commission ▶ Jobs.

  2. Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and "Creating Configuration Jobs Using Data Sets".

  3. Select SNMP agent in the left pane. The SNMP agent tab is displayed.
    Setting Up an SNMP Agent Configuration Job_1.PNG

  4. Complete all fields in the SNMP agent tab as required. For more information on specific parameters, see the table below.

  5. Click Apply, then click Close.

  6. Click the Refresh REFRESH BUTTON.png button to refresh the user interface.

SNMP agent tab (Commission ▶ Jobs)

General

ParameterDescription
Enable SNMP agentEnables the SNMP agent.
Use host name as system nameUses the element's host name as system name in outgoing messages.
SNMP system nameThe name to identify the element in SNMP messages. By convention, this is the element's fully qualified domain name.
System locationPhysical location of the element.
UDP portUDP port that the SNMP agent uses for all IPv4 interfaces.

Note: Changing this value restarts the SNMP agent.

Contact informationContact information for the element (typically an email address).
Read-only communityThe community string to control read-only access to the element.
Enable authentication trap generationEnables the element to generate a trap when authentication to the agent fails.
Read-write communityThe community string to control read/write access to the element.
Enable link trap generationEnables trap generation when link status changes.

Map to the generic traps 2 (1.3.6.1.6.3.1.1.5.3 linkDown) and 3 (1.3.6.1.6.3.1.1.5.4 linkUp).

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.