Login
Contents x
Testing Redundancy
  • 27 Jun 2023
  • 1 Minute to read
  • Contributors
  • Print
  • PDF
Contents

Testing Redundancy

  • Updated on 27 Jun 2023
  • 1 Minute to read
  • Contributors
  • Print
  • PDF
Article summary

After the redundancy feature has been configured, enabled and started, you can check that it is operating normally with the redundancy test command.

This command is executed from the appliance console. For more information about the appliance console, see Accessing the Appliance Console.

  1. Ensure that redundancy is started by entering:
    redundancy show status

  2. Run the test by entering:
    redundancy test

The output of the test will be similar to the following:
28.png

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks


Was this article helpful?
What's Next
© 2024 Cisco Privacy Statement Cookies Legal
Change password!
Changing your password will log you out immediately. Use the new password to log back in.
Change profile
Success!
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.
Logout