Redundancy Commands – CLI Help and Command Summary

Updated on 19 Dec 2023
1 Minute to read
Contributors

Article summary

Did you find this summary helpful?

Thank you for your feedback

Tab-completion help is available for the redundancy commands on the Skylight orchestrator command line.

The following tables of redundancy commands list all the parameters and possible parameter values.

redundancy config

Parameters	Possible parameter values
auto-failover	enable, disable
monitor-port	default
preferred	none, site-a, site-b
replication-port
site-a	hostname of appliance at Site-A
site-b	hostname of appliance at Site-B

redundancy config virtual-ip

Parameters	Possible parameter values
vip-address	IP address used as single point of access to Skylight orchestrator system
vip-primary-interface	Any interface defined for the virtual IP address. Default: eth0
vip-state	enable, disable

redundancy control

Parameters	Possible parameter values
restart	--
resume	--
set-preferred-site	none (default), site-a, site-b
start	--
stop	--
suspend	--
switch	--
handle-split-brain	--

redundancy license

Parameters	Possible parameter values
import	fullPath/licenseFilename
reset	--

redundancy show

Parameters	Possible parameter values
configuration	--
statistics	--
status	--

© 2024 Cisco and/or its affiliates. All rights reserved.

For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks

Was this article helpful?

What's Next

Alarms Related to Redundancy