To set up packet loss instances
-
Access the page SOAM â–¶ CFM â–¶ Packet Loss â–¶ Configuration.
A listing of all existing packet loss instances is displayed. -
Click Add to create a packet loss instance or click the packet loss instance index to edit an existing packet loss instance.
-
Complete the required fields, then click Apply.
For more information on specific parameters, refer to the following table.
Packet Loss Configuration (SOAM â–¶ CFM â–¶ Packet Loss â–¶ Configuration)
| Parameter | Description |
|---|---|
| Index | The packet loss instance unique identifier |
| PL Name Name |
The name of the packet loss instance. |
| MEP Index MEP idx |
The index assigned to the Maintenance association End Point |
| MEPID | The local Maintenance association End Point Identifier |
| Remote MEPID R-MEPID |
The remote Maintenance association End Point Identifier Note: A peer MEP should have the sequence number enabled to allow a local MEP to perform CCM-based packet loss measurements. |
| Priority | The Priority value to be used in VLAN tags, if present, in the transmitted frame. Same as MEP's CCM priority. |
| Interval | The Interval between packet loss measurements. This value is inherited from the MA/MEG's CCM interval. |
| Enable | Enables packet loss measurements. |
| Reference Period | Specify the reference period in minutes. |
| Threshold | Specify (as a percentage) the maximum ratio of packets lost allowed before issuing an alarm during the reference period. |
© 2025 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and trademarks