Setting Up a DMM Configuration Job
  • 21 Jun 2024
  • 1 Minute to read
  • Contributors
  • PDF

Setting Up a DMM Configuration Job

  • PDF

Article summary

Delay Measurement Messages (DMM) are used to measure network delay and network delay variation. DMM measurements are part of the Service OAM functionality supported by Skylight orchestrator. You can enable DMM delay measurements on a Skylight sensor: control or a Skylight element using a configuration job.

To set up a DMM Reflector configuration job

  1. Access the page Commission ▶ Jobs.

  2. Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".

  3. Select DMM Reflector in the left pane. The DMM Reflector tab is displayed.
    Setting Up a DMM Configuration Job_1.PNG

  4. Complete all fields in the DMM Reflector tab as required. For more information on specific parameters, see the table below.

  5. Click Apply, then click Close.

  6. Click the Refresh Button_Refresh_Generic.png button to refresh the user interface.

DMM Reflector tab (Commission ▶ Jobs)

General

ParameterDescription
EnableCheckbox to enable or disable the DMM reflector.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.