Installation Procedure for Accedian Board

Updated on 30 May 2024
1 Minute to read
Contributors

Article summary

Did you find this summary helpful?

Thank you for your feedback

Connecting to the Board

There is an RJ45 console as a serial connection, 115200 N81; this console displays boot messages as it is a connection to the unit. The default user is root, the default password is admin123.

SSH and Telnet connections over IPv4 are supported after IP address configuration.

Note: Telnet is disabled by default and must be configured. See Enabling Telnet.

SSH Procedure

From a Linux server, the following command establishes an SSH client session with the specified OOB management interface IP address.

The following command should be used for CLI reachability via management port from a host.

#ssh -o KexAlgorithms=diffie-hellman-group14-sha1 root@<flex-ip-address>

© 2024 Cisco and/or its affiliates. All rights reserved.

For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks

Was this article helpful?

What's Next

Initial Configuration Guidelines

Table of contents

Connecting to the Board