Configuring LLDP System Control Status
- 24 Apr 2023
- 1 Minute to read
- Contributors
- Print
- PDF
Configuring LLDP System Control Status
- Updated on 24 Apr 2023
- 1 Minute to read
- Contributors
- Print
- PDF
Article summary
Did you find this summary helpful?
Thank you for your feedback
This section explains the LLDP configuration for System Control status, which is set to Start by default. LLDP System Control status must be in Start state in order to perform LLDP configurations.
- Shutdown LLDP by executing the following commands
- Enter the Global Configuration mode.
your product# configure terminal
- Shutdown LLDP.
your product(config)# shutdown lldp
- Exit from the Global Configuration mode.
your product(config)# end
- View the LLDP system control status by executing the following command.
your product# show lldp
% Lldp Module is shutdown
- Start LLDP by executing the following commands:
- Enter the Global Configuration mode.
your product# configure terminal
- Start LLDP.
your product(config)# no shutdown lldp
- Exit from the Global Configuration mode.
your product(config)# end
Note: Once the LLDP system control status is changed to Start, LLDP global configuration objects are set with default values.
- View the default values of LLDP global configuration objects by executing the following command.
your product# show lldp
LLDP is disabled
Transmit Interval : 30
Holdtime Multiplier : 4
Reinitialization Delay : 2
Tx Delay : 2
Notification Interval : 5
Chassis Id SubType : Mac Address
Chassis Id : 00:01:02:03:04:01
© 2024 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks
Was this article helpful?