Pre-aggregate Binning
  • 03 Apr 2023
  • 1 Minute to read
  • Contributors
  • PDF

Pre-aggregate Binning

  • PDF

Article summary

From the Dashboard, you can set-up pre-aggregate bins on a session metric for the Table, Timeseries, and Crosstab widgets.

Use pre-aggregate bins to segment measurements before aggregation is applied. Each bin is represented by a color that conforms to a condition. You can color bins, for example, to reflect good and bad ranges.

Set up Pre-aggregate Bins

When setting up bins, you can link to a predefined threshold profile or define how you want to segment measurements.

To set up pre-aggregate bins:

  1. In Author mode, click Set up bins in the Data section.
  2. Click (Pre-aggregate) segment measurements into bins.
  3. Select the binning method:
    • Profile: Link a pre-aggregate profile. More information: Threshold Profiles
    • Segment measurements by value: Count the record if its value crosses a fixed value
    • Segment measurements by value from baseline: Count the record if its value crosses a baseline plus or minus a value (for example, 20 ms over baseline)
    • Segment measurements by % from baseline: Count the record if its value crosses a baseline plus or minus a percentage (for example, 10% over baseline)
  4. Configure the parameters.
    • For Profile, select the profile from the dropdown list.
    • For Segment measurements by ..., click Add bin + , and then set the parameters under Value and Shown as to define the condition and bin color. Repeat this step as needed.
  5. Click on the upper right to save your changes.

timeseries binning 2.gif

Examples

Here are examples of how bins appear in dashboard widgets:

Bins in a Timeseries widget
image.png

Bins in a Table widget
image.png

Bins in a Crosstab widget
image.png

Drill Down to Analysis

Once you've set up bins, you can drill down to bring bins into analysis as a filter.

drilldown.gif

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

What's Next
Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.