Setting Up Credentials for Devices
  • 13 Aug 2024
  • 2 Minutes to read
  • Contributors
  • PDF

Setting Up Credentials for Devices

  • PDF

Article summary

Legacy orchestrator can connect automatically to devices, such as Provider Connectivity Assurance Sensor Control and Provider Connectivity Assurance Sensors, using credentials. Credentials allow Legacy orchestrator to log in on devices directly—no human operator intervention is required. A credential includes the user ID and password for a user account that must be available on one or more devices that Legacy orchestrator will access. When you add a devices to the list of Managed Elements in Legacy orchestrator, you must select a valid credential as a parameter for the device. This will allow Legacy orchestrator to log in on the devices directly. The same credential can be used for many devices.

The Credentials page lists credentials that have already been defined and allows you to define additional credentials.


Note: Legacy orchestrator manages several types of user accounts including:

Credential accounts (listed in the Devices ▶ Credentials page). These accounts allow Legacy orchestrator to access the elements it manages.

Legacy orchestrator user accounts (listed in the Admin ▶ Users page). These accounts give users access to the Legacy orchestrator web interface.

To view the list of existing credentials

Select Devices ▶ Credentials. The list of all credentials that have already been defined on Legacy orchestrator is displayed.

To add a credential

  1. Click the Add Credential Button_New_Generic.png button (above top left corner of the list) to add a new credential, or double-click an existing entry to change the credential parameters.
    The credential configuration section is displayed on the far right of the Credentials page.

  2. Set the credential settings, click Save and then click Close.For more information on specific parameters, see the table below this procedure.


Note: The default credentials for all Assurance Sensors (GT, LT and LX) are: user ID= admin and password = admin.

The following table describes the parameters that must be set for a credential.

Credentials (Devices ▶ Credentials)

ParameterDescription
Credential nameThe name of the credential used for a certain group of devices. The credential includes the user ID and password for an administrator account present on all devices in the group. Legacy orchestrator will be able to log in to any of the devices using this credential.

Typically, the credential name is the same as the user ID of the administrator account on the devices.

TypeUSERID_BASED: Only supported value. USERID_BASED means that the credential refers to a user account that is available on each of the devices to be accessed using this credential.
UsernameA user account with this ID must be available on all devices that Legacy orchestrator will access using this credential. Legacy orchestrator requires a user account with ADMIN-level privileges on the devices. If insufficient privileges are granted, Legacy orchestrator will not be able to access the devices.

The default user account for all Assurance Sensors (GT, LT, LX and so on) is​:

  • user ID: admin
  • password: admin
PasswordPassword for the user account.

To delete a credential

  1. Select an entry in the Credentials list.

  2. Click the Remove credential  Button_Remove_Generic.png  button (above top left corner of the list).

  3. Click OK in the confirmation dialog to remove it from the list.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.