Setting Up a Device Attributes Configuration Job
  • 19 Sep 2024
  • 1 Minute to read
  • Contributors
  • PDF

Setting Up a Device Attributes Configuration Job

  • PDF

Article summary

You can use a device attributes configuration job to replace the credentials or label associated with a device.

To set up a Device attributes configuration job

  1. Access the page Commission ▶ Jobs.

  2. Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".

  3. Select Device attributes in the left pane. The Device attributes tab is displayed.
    Setting Up a Device Attributes Configuration Job.png

  4. Complete all fields of the Device attributes tab as required. For more information on specific parameters, see the table below.

  5. Use the Add Button_New_Generic.png button or Duplicate Button_Duplicate.png button to add Device attributes settings as required.


    Note: When duplicating a row, always select the row to duplicate before clicking the Duplicate  Button_Duplicate.png button.

  6. Click Apply, then Close.

  7. Click the Refresh Button_Refresh_Generic.png button to refresh the user interface.

Device attributes tab (Commission ▶ Jobs)

General

ParameterDescription
Credential nameSelect a credential from the drop-down list. The credentials in the list have been previously defined in Legacy orchestrator in the Device Management ▶ Device Credentials page.

Note: If the selected credential does not have administrator permissions, operation of the device and communication with the device may be impaired.

LabelThe label to be assigned to the device. The label is listed on the Device Management ▶ Managed tab. If this value is blank, the label is not modified.
Verify credential
  • True: During execution of the configuration job, Legacy orchestrator will validate that it can re-establish communication with the device using the selected credential. If communication cannot be established, the job will fail for the device.
  • False: The configuration job will run without validating that communication can be established with the selected credential.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.