Viewing Dry-Contact Alarms
  • 09 Aug 2024
  • 1 Minute to read
  • Contributors
  • PDF

Viewing Dry-Contact Alarms

  • PDF

Article summary

To view the status of dry-contact-related alarms

  1. Access the page System ▶Alarm ▶Dry-Contact
    The dry-contact alarm status is displayed for each of the unit's inputs.

For more information on specific parameters, refer to the following table.

Dry-Contact Alarms (System ▶Alarm ▶Dry-Contact)

ParameterDescription
Operational StateThe current state of the dry-contact input, i.e. Enabled or Disabled.

When enabled, the alarm point for this input is created and the input is monitored.

Normal Input StateThe input's normal state, i.e. Closed or Opened.

An alarm is raised when the input state of the dry-contact is different from the normal state for more than three consecutive samples.

Input Pin StateThe current state of the dry-contact input.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.