Using Service OAM

Updated on 25 Sep 2024
1 Minute to read
Contributors

Article summary

Did you find this summary helpful?

Thank you for your feedback

The subsequent articles describe the IEEE 802.1ag “Service OAM” function and how to set it up on your Metro Ethernet Network to perform end-to-end monitoring.

Service OAM (or CFM Connectivity Fault Management) encompasses fault management and performance management capabilities of the Cisco Provider Connectivity Assurance Sensor Control.

Note: The Sensor Control’s implementation of Service OAM is primarily focused on reflecting loopback message frames and delay measurements.

Note: The port status may become yellow under these circumstances:
EVC-FP (Ethernet Virtual Connection Fault Propagation)
ETH-CSF (Ethernet Client Signal Failure)
LLF-FP (Link Loss Forwarding Fault Propagation)

The following figure shows an overview of Service OAM.

Overview of Service OAM

© 2024 Cisco and/or its affiliates. All rights reserved.

For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks

Was this article helpful?

What's Next

Setting Up CFM