TWAMP Control Compatibility Matrix
  • 21 Jun 2024
  • 1 Minute to read
  • Contributors
  • PDF

TWAMP Control Compatibility Matrix

  • PDF

Article summary


Note: The commands may have changed and need to be validated with the 3rd party.

Depending on vendor of the TWAMP-Control server (reflector) the Skylight solution TWAMP solution has implemented operation in two distinct modes .

The parameter, called “Legacy Mode”, to configure this can be found in the Analyzer Client under “TWAMP Control” Configuration for each external reflector making use of the control protocol. For more information see, "Managing Reflectors"

To ensure compatibility of the control protocol between the Skylight system and the 3rd party device use the guidelines seen in the table below.

VendorLegacy Mode Setting
HuaweiEnabled
SamsungDisabled
JuniperDisabled
Nokia (ALU 77 xx)Disabled
CiscoDisabled

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.