Provider Connectivity Assurance
Support Portal
cisco.com
Login
Contents
x
Getting Started
Provider Connectivity Assurance
Legacy Orchestrator
Skylight Gateway
Assurance Sensor Agents
Assurance Sensor Capture
Assurance Sensor Control
Assurance Module Dock
Assurance Sensor Modules
Assurance Sensor SFP
Assurance Sensor GT-GT-S, LT-S, and LX-S
Assurance Sensor F100 and F25
Partner Enablement
Accedian Skylight Legacy Products and Documentation
Legal
Powered by
Testing Network Performance
5 Articles
in this category
Contributors
Share this
Print
Share
Contents
Testing Network Performance
5 Articles
in this category
Written by
Andrea Hilton
Share
Using RFC-2544 for Traffic Generation and Analysis
Use the traffic generator and monitor to pinpoint devices or network problems, or to measure current throughput, frame delay, and frame delay variation on a specific network segment. This article describes how to set up your Carrier Ethernet network...
Written by
Andrea Hilton
Updated on : 07 Aug 2024
Using the RFC-2544 Test Suite
Use a test suite to determine whether a network section or a device conforms to a Service Level Agreement (SLA) or an Ethernet standard. This procedure consists of: Setting up a test suite Running a test suite Viewing a test report N...
Written by
Andrea Hilton
Updated on : 07 Aug 2024
Using Y.1564 for Service Activation Testing
Y.1564 is used to perform end-to-end Ethernet service activation tests (SAT). The following sections describe how to set up Y.1564 in your Metro Ethernet network. The implementation of Y.1564 supports the following types of tests: Layer-2 two-...
Written by
Andrea Hilton
Updated on : 07 Aug 2024
Setting Up SAT Reporting
You can set up the unit to enable the transfer of SAT test reports to a server. Once enabled, test reports are automatically transferred to the server each time a test is completed. Test reports are available for Y.1564. All reports are available ...
Updated on : 24 Jan 2024
Testing Locally-Created Services
Services that have been created locally on the unit can be included in a Y.1564 or RFC-2544 test by enabling an internal loopback on one of the unit’s UNI ports to redirect the test traffic through the traffic policies. A test where an internal lo...
Updated on : 05 Oct 2022
Change password!
Changing your password will log you out immediately. Use the new password to log back in.
Current password
Current password is required
New password
New password must be at least 8 characters long. It should contain at least one upper and lower case letter, number, and a special character.
Confirm password
Confirm password must be at least 8 characters long. It should contain at least one upper and lower case letter, number, and a special character.
Confirm password should be same as new password
Update
Change profile
Success!
First Name
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last Name
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
New email
Enter a valid email
Re-enter your password
Enter a valid password
Your profile has been successfully updated.
Update
Logout