Skylight performance element: LX Release Notes 7.9.5
  • 09 Aug 2024
  • 2 Minutes to read
  • Contributors
  • PDF

Skylight performance element: LX Release Notes 7.9.5

  • PDF

Article summary

These release notes cover the requirements, new features, and changes for the Skylight Element: LX firmware version 7.9.5. Please read all notes prior to installing this firmware version. For more information, refer to: User Material for Skylight performance element: LX

Requirements

This firmware version applies to the following Skylight element: LX, resulting from changes in the TLS version, the following software versions are compatible with SkyLIGHT Director Version 1.3 (now Skylight orchestrator) and above:

  • 7.1.1.1
  • 7.3.0.3
  • 7.4
  • 7.5
  • 7.6
  • 7.7
  • 7.8
  • 7.8.1
  • 7.8.2
  • 7.8.2.1
  • 7.8.3
  • 7.9
  • 7.9.1
  • 7.9.2
  • 7.9.3
  • 7.9.4
  • 7.9.5


Note: There is a patch available for earlier versions of Skylight orchestrator. Please contact Accedian support for further information.

Firmware Version 7.9.5_25216 (2022-12-13)

New Features and Enhancements

Password length/complexity
Increased authentication methods to support up to 128-character password.

SAT test with single flow at 10G
To support the SAT Y.1564 test with the flow configuration at 10 Gbps, the maximum value of CIR/EIR specified in the bandwidth profile setting has been modified from 1250 Mbps to 10000 Mbps. This change will allow the user to configure and run a SAT Y.1564 test with the flow at 10 Gbps.

Operational Considerations

Important Notes

  • The Skylight element: LX firmware is delivered in a consolidated file prefixed by “ACC”, e.g. ACC_7.X_YYYY.afl. This file contains the firmware for the GT, GX , LX and LT Performance Element products. It cannot be used with any other product.
  • IMPORTANT: Prior to upgrading the firmware on a unit where the History Buckets feature is enabled, certain precautions may need to be taken to prevent a loss of history data during the upgrade.
  • After upgrading to 7.9.1 or 7.9.2, the SCP is no longer able to send files, reporting the following error: Code = 3: URL using bad/illegal format or missing URL. This is due to a syntax change and customer needs to edit the URL after upgrading to 7.9.2 or 7.9.3.
    The URI generic syntax (in RFC 3986) consists of a hierarchical sequence of five components: URI = SCHEME ':' ['//' AUTHORITY] PATH ["?" QUERY] ["#" FRAGMENT]. In this, AUTHORITY = [USER_INFO "@"] HOST [":" PORT]. The AUTHORITY part and the PATH part are isolated by the slash ('/') character if the AUTHORITY exists.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.