Setting Up VSP

  • Published on Aug 9, 2024
  • 1 minute(s) read
  • AH
 Prev Next

The VSP function is used to reflect VSP (vendor-specific) frames to the sender.

Note: This function is to be used only with VSP when connecting to Layer-2 VSP actuator devices.

To set up the VSP function

  1. Access the page SOAM â–¶CFM â–¶ VSP â–¶Configuration.

  2. Complete the required fields, then click Apply.

For more information on specific parameters, refer to the following table.

VSP Configuration (SOAM â–¶CFM â–¶VSP â–¶Configuration)

Parameter Description
Enable The state of the instance (disabled by default).
MEG Level The MEG level of the reflector:
  • Frames with the MEG level equal to this setting are reflected.
  • Frames with the MEG level higher than this setting are forwarded.
Range: All, 0–7

Note: When All is selected, all frames are reflected.

Viewing VSP Results

To view VSP Results

  1. Access the page SOAM â–¶CFM â–¶ VSP â–¶Results.
    Current VSP results are displayed.

For more information on specific parameters, refer to the following table.

VSP Results (SOAM â–¶CFM â–¶ VSP â–¶Results)

Parameter Description
Index The index assigned to the VSP instance.
Src Mac The MAC address for the remote unit (the source).
Dst Mac The MAC address for this unit's reception port (the destination).
VLAN ID The VLAN ID of the VSP frames received.
MEG Level The MEG level of the VSP frames received.
Rx Count The number of VSP frames received.
Tx Count The number of VSP frames reflected.

© 2025 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks