Setting Up VSP
- 29 Nov 2022
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Setting Up VSP
- Updated on 29 Nov 2022
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Article Summary
Share feedback
Thanks for sharing your feedback!
The VSP function is used to reflect VSP (vendor-specific) frames to the sender.
Note: This function is to be used only with VSP when connecting to Layer-2 VSP actuator devices.
To set up the VSP function
Access the page SOAM ▶CFM ▶ VSP ▶Configuration.
Complete the required fields, then click Apply.
For more information on specific parameters, refer to the following table.
VSP Configuration (SOAM ▶CFM ▶VSP ▶Configuration)
| Parameter | Description |
|---|---|
| Enable | The state of the instance (disabled by default). |
| MEG Level | The MEG level of the reflector:
Note: When All is selected, all frames are reflected. |
Viewing VSP Results
To view VSP Results
- Access the page SOAM ▶CFM ▶ VSP ▶Results.
Current VSP results are displayed.
For more information on specific parameters, refer to the following table.
VSP Results (SOAM ▶CFM ▶ VSP ▶Results)
| Parameter | Description |
|---|---|
| Index | The index assigned to the VSP instance. |
| Src Mac | The MAC address for the remote unit (the source). |
| Dst Mac | The MAC address for this unit's reception port (the destination). |
| VLAN ID | The VLAN ID of the VSP frames received. |
| MEG Level | The MEG level of the VSP frames received. |
| Rx Count | The number of VSP frames received. |
| Tx Count | The number of VSP frames reflected. |
© 2024 Accedian Networks Inc. All rights reserved. Accedian®, Accedian Networks®, the Accedian logo™, Skylight™, Skylight Interceptor™ and per-packet intel™, are trademarks or registered trademarks of Accedian Networks Inc. To view a list of Accedian trademarks visit: http://accedian.com/legal/trademarks/.
Was this article helpful?
