Setting Up Virtual Connection Endpoints (VCEs)
  • 30 Mar 2022
  • 1 Minute to read
  • Contributors
  • Dark
    Light
  • PDF

Setting Up Virtual Connection Endpoints (VCEs)

  • Dark
    Light
  • PDF

Article Summary

To view a summary of existing VCEs

  1. Access Virtual Connection ▶VCE ▶Configuration.

A list of all existing VCEs and their current status is displayed.


Note: A type Tunnel VCE will create an implicit VCA which can be included within another VCA. Also, a VCE with both TP A and TP Z ports configured as external will generate an implicit VCA.

For more information on specific parameters, refer to the following table.

VCE Configuration and Status (Virtual Connection ▶VCE ▶Configuration)

ParameterDescription
VCE NameA name that uniquely identifies the VCE on the Skylight element: LX.
TPIDThe TPID (Tag Protocol Identifier). Specifies the type of VLANtagging used in the frames that will be handled by this VCE.

Available tag protocol options are:

  • 0x8100: C-VLAN
  • 0x88a8: S-VLAN
  • 0x9100: T-VLAN
TP AThe TP A is the Terminal Point interface. Can be:
  • Internal: Used to identify the TP as being connected to another VCE.
  • External: Used to identify the TP as being connected to an external port.
TP A VIDUsed to indicate the VLANIDs expected for this VCE configuration. When Frame Type is 'all-to-one', this value is irrelevant, and '---' is displayed.
TP ZThe TP Z is the Terminal Point interface. Can be:
  • Internal: Used to identify the TP as being connected to another VCE.
  • External: Used to identify the TP as being connected to an external port.
TP Z VIDTP Z VID is applicable when 'vid-relay-action' is set to 'translate' or 'tag'. Only a single value for the VID may be specified.
Component IDThe ID of the Component into which the VCE will be attached. Specifying 0 indicates that the system shall automatically assign a component ID.

To add a new VCE or edit an existing VCE


CAUTION: Before you can add a VCE to a Skylight module, you must add a standard logical interface to it. For details, see "Configuring Logical Interfaces".

  1. Access Virtual Connection ▶VCE ▶Configuration.
    A list of all existing VCEs and their current status is displayed.

  2. Click Add to create a new VCE or click the Name of an existing VCE to edit its settings.

© 2024 Accedian Networks Inc. All rights reserved. Accedian®, Accedian Networks®,  the Accedian logo™, Skylight™, Skylight Interceptor™ and per-packet intel™, are trademarks or registered trademarks of Accedian Networks Inc. To view a list of Accedian trademarks visit: http://accedian.com/legal/trademarks/. 


Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.