You can use a configuration job to define VID sets for each traffic stream on a device to classify the incoming traffic before sending it to the service creation function. A VID set consists of one or more VLANs grouped as a logical entity.
To set up a VID sets job
-
Access the page Commission â–¶ Jobs.
-
Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".
-
Select VID Sets in the left pane. The VID sets tab is displayed.
-
Complete all fields of the VID sets tab as required. For more information on specific parameters, see the table below.
-
Use the Add
button or Duplicate 
button to add VID sets as required. -
Click Apply, then click Close.
-
Click the Refresh
button to refresh the user interface.
VID sets tab (Commission â–¶ Jobs)
VID Sets
| Parameter | Description |
|---|---|
| Name | The name assigned to the VID set. |
| Policy list | Assigned when the VID set is created, the policy list indicates the traffic policy to which the VID set applies. The value here is the policy list on which the VID set will be active. |
| VLAN type | The VLAN Ethertype of the VID set:
|
| VIDs | Specify a list of VIDs in the following format: [- ], [- ] ... (e.g. 1, 2, 100–200 will include VIDs 1, 2, 100, 101, 102, 103... 200). Note: With a catch-all filter, you must assign VID 0–4095. For untagged frames, assign VID 0. |
| Outer VLAN type | The VLAN Ethertype for the outer VLAN (when dual VLAN is used). Possible values:
|
| Outer VLAN ID | Specify a VID for the outer VLAN. |
© 2025 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks