Setting Up a Traffic Configuration Job

The VLAN level for each traffic port on a device must be configured to be used with one or two VLAN tags in the VLAN filters.

When the VLAN level setting is configured as Outer (default), the VLAN filter is matched against the outer VLAN of incoming frames. With this option, the outer VLAN ID can only be used once per port in the VID sets.

When the VLAN level setting is configured as Inner, the VLAN filter is matched against both outer and inner VLANs of incoming frames. With this option, the inner VLAN ID can only be used once per port in the VID sets.
In all cases, the VLAN type must match the filters.

To set up a Traffic configuration job

1. Access the page Commission ▶ Configuration Jobs.

2. Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".

3. Select Traffic configuration in the left pane. The Traffic configuration tab is displayed.
   

4. Complete all fields in the Traffic configuration tab as required. For more information on specific parameters, see the table below.

5. Click Apply, then click Close.

6. Click the Refresh button to refresh the user interface.

Traffic configuration Tab (Commission ▶ Jobs)
Traffic configuration (General)

Rate settings