You can use a device attributes configuration job to replace the credentials or label associated with a device.
To set up a Device attributes configuration job
-
Access the page Commission â–¶ Jobs.
-
Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".
-
Select Device attributes in the left pane. The Device attributes tab is displayed.
-
Complete all fields of the Device attributes tab as required. For more information on specific parameters, see the table below.
-
Use the Add
button or Duplicate 
button to add Device attributes settings as required.
Note: When duplicating a row, always select the row to duplicate before clicking the Duplicate button.
-
Click Apply, then Close.
-
Click the Refresh
button to refresh the user interface.
Device attributes tab (Commission â–¶ Jobs)
General
| Parameter | Description |
|---|---|
| Credential name | Select a credential from the drop-down list. The credentials in the list have been previously defined in Legacy Orchestrator in the Device Management â–¶ Device Credentials page. Note: If the selected credential does not have administrator permissions, operation of the device and communication with the device may be impaired. |
| Label | The label to be assigned to the device. The label is listed on the Device Management â–¶ Managed tab. If this value is blank, the label is not modified. |
| Verify credential |
|
© 2025 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks