Setting Up a Clocks Configuration Job
  • 21 Jun 2024
  • 1 Minute to read
  • Contributors
  • PDF

Setting Up a Clocks Configuration Job

  • PDF

Article summary

A clocks configuration job allows you to set up a Time of Day (ToD) clock on a Skylight sensor: control. The job sets up a distributed clock that does not use PTP as its reference source.

To set up a Clocks configuration job

  1. Access the page Commission ▶ Jobs.

  2. Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and in "Creating Configuration Jobs Using Data Sets".

  3. Select Clocks in the left pane. The Clocks tab is displayed.
    Setting Up a Clocks Configuration Job_1.PNG

  4. Complete all fields in the Clocks tab as required. For more information on specific parameters, see the table below.

  5. Click Apply, then click Close.
    Click the Refresh  Button_Refresh_Generic.png  button to refresh the user interface.

Clocks tab (Commission ▶ Jobs)

General

ParameterDescription
Clock nameName by which the clock will be identified on the devices being configured.
Rename clockCheck this box if the job will rename a clock that was previously defined on the units being configured.
New clock nameEnter a new name for the clock if the job will rename a clock that was previously defined on the units being configured.
ModuleName of the module on which the clock will be configured.
Enable ARTSEnable the use of Accedian Remote Time Synchronization (ARTS) to set the time of the clock.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.