Setting Up a Bandwidth Regulator Set Configuration Job

A bandwidth regulator set is used to regulate traffic bandwidth based on the value of the following information for the incoming frames:

• PCP: p-bits in 802.1Q / 802.1Q-in-Q tags.
• IP Precedence: IP precedence bits in the IPv4 ToS byte or in the IPv6 Traffic Class byte.
• DSCP: DSCP bits in the IPv4 ToS byte or in the IPv6 Traffic Class byte.

To set up a Bandwidth regulator sets configuration job

1. Access the page Commission ▶ Jobs.

2. Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and "Creating Configuration Jobs Using Data Sets".

3. Select Bandwidth regulator sets in the left pane.
   The Bandwidth regulator sets tab is displayed.
   

4. Complete all fields in the Bandwidth regulator sets tab as required. For more information on specific parameters, see the table below.

5. Click the Add  button or Duplicate button to add bandwidth regulator sets as required.
   

   ---

   Note: When duplicating a row, always select the row to duplicate before clicking the Duplicate   button.

   ---

6. Click Apply, then click Close.

7. Click the Refresh  button to refresh the user interface.

Bandwidth regulator sets tab (Commission ▶ Jobs)

General

Regulator parameters (tabs: PCP 0-3, PCP 4-7, IP Precedence 0-3, IP Precedence 4-7, DSCP 0-3, and so on)