Target Installation Procedures

Updated on 21 Jun 2024
1 Minute to read
Contributors

Article summary

Did you find this summary helpful?

Thank you for your feedback

The rehome operation can be rolled back by stopping the application on the target installation and restarting the application on the source installation.

Target Installation Procedures

Stopping the Application

The procedure to stop the application is different for hot standby setups.

Note: If you are rehoming a redundant configuration, these steps must be run on the active site.

If you are operating in a Hot Standby configuration

Open an SSH terminal session to the Skylight orchestrator on port 2200.
Log in as the visionems user.
Stop the Hot Standby process by entering: redundancy control stop

Otherwise

Open an SSH terminal session to the Skylight orchestrator on port 2200.
Log in as the visionems user.
Stop the application by entering: service stop app_server

Starting the Application

This procedure starts the hot standby process, and also starts the application.

If you are operating in a Hot Standby configuration

Open an SSH terminal session to the Skylight orchestrator designated as the preferred active site on port 2200.
Log in as the visionems user.
Start the Hot Standby process by entering:
redundancy control start

Otherwise

Open an SSH terminal session to the Skylight orchestrator on port 2200.
Log in as the visionems user.
Start the application by entering:
service start app_server

{

© 2024 Cisco and/or its affiliates. All rights reserved.

For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks

Was this article helpful?

What's Next

Source Installation Procedures

Table of contents