Provider Connectivity Assurance
Support Portal
cisco.com
Login
Contents
x
Getting Started
Provider Connectivity Assurance
Legacy Orchestrator
Skylight Gateway
Assurance Sensor Agents
Assurance Sensor Capture
Assurance Sensor Control
Assurance Module Dock
Assurance Sensor Modules
Assurance Sensor SFP
Assurance Sensor GT-GT-S, LT-S, and LX-S
Assurance Sensor F100 and F25
Partner Enablement
Accedian Skylight Legacy Products and Documentation
Legal
Powered by
Managing Loopbacks
2 Articles
in this category
Contributors
Share this
Print
Share
Contents
Managing Loopbacks
2 Articles
in this category
Share
Understanding Loopback Testing
Layer 1–4 loopbacks (MAC address, IP address & port swap) permit remote QoS testing for Ethernet, IP/MPLS and triple-play services. Loopbacks can be established by any of the following combination of parameters: Source or destination address...
Updated on : 15 Dec 2021
Setting Up and Enabling Loopbacks
Follow the steps below to set up a local loopback: Define filters for capturing traffic (required for custom loopbacks only), "Defining Filters". Create an OAM instance, see "Setting Up an OAM Instance". Create the loopback, as explained in ...
Updated on : 25 Jan 2024
Change password!
Changing your password will log you out immediately. Use the new password to log back in.
Current password
Current password is required
New password
New password must be at least 8 characters long. It should contain at least one upper and lower case letter, number, and a special character.
Confirm password
Confirm password must be at least 8 characters long. It should contain at least one upper and lower case letter, number, and a special character.
Confirm password should be same as new password
Update
Change profile
Success!
First Name
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last Name
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
New email
Enter a valid email
Re-enter your password
Enter a valid password
Your profile has been successfully updated.
Update
Logout