Getting Started

Ethernet Service (EPL) QOS – srTCM, trTCM, MEF10.2, MEF10.3 CIR : Committed Information Rate CBS : Committed Burst Size EIR : Excess Information Rate EBS : Excess Burst Size CF : Coupling Flag (Enabled/Disabled) CM : Color ...

The following key features are supported by Provider Connectivity Assurance Sensor F100 and F25: Device Infrastructure and Management Features SNMP (v2c, v3) agent and MIB support NETCONF support Configuration Save and Restore CLI (Conso...

Connecting to the Board There is an RJ45 console as a serial connection, 115200 N81; this console displays boot messages as it is a connection to the unit. The default user is root , the default password is admin123 . SSH and Telnet connection...

The following procedures must be performed from the console port. IP Management for Out-of-Band Management DHCP Client Configuration Procedure The following command configures the OOB management interface to dynamically acquire the IP address ...

Configuring the Unit The basic configuration involves configuring the IP address, VLAN, and so forth. The executable comes up with a VLAN already configured. This VLAN is called the default VLAN (VLAN ID = 1). All ports in the switch are members...

Configuring the Default IP Address Configuring the Default IP Address will result in the IP address to be written to the NVRAM and this will be used as the IP address of the default interface when the switch is restarted. Note: To log in...

Configuring IP address for an Interface Configuring IP address for an Interface configures the IP address which will be used for sending and receiving the packets. Note: To log in, enter your username (default is root) and password (defa...

This article explains how to configure the console port; more precisely, to enable or disable console CLI through the serial port as well as display the current information stored in non-volatile random-access memory (NVRAM). Note: To log in,...

Static IP and Default Gateway Configuration To configure the IP address Use the following command on the console: Your Product# configure terminal Your Product (config)# interface cpu0 Your Product (config)# shutdown Your Product (conf...

You can reset the unit to its factory default settings either by using the RST button on the panel of the unit or by using the CLI. Each way is described below. CAUTION: Resetting to factory default settings affects current operations. ...

Overview The following procedure is recommended to upgrade a Provider Connectivity Assurance Sensor F100 or F25 unit using the AFL file and the CLI. The Assurance Sensor F100 and F25 platforms have enough space on the storage to save two copies of...