Shutdown Interface

Prev Next

This article describes the configuration of interface P2 to raise a defect/fault in sample topology.

CLI Configurations

At Switch5

  • Make interface P2 as down.
your product(config)# interface gigabitethernet 0/2
your product(config-if)# shutdown
  • Wait for 15 seconds to check for any link failure (error/fault/defect).

SNMP Configurations

At Switch5

  • Make interface P2 as down. [Index: Interface Number = 2]
% snmp0 set {{ifMainAdminStatus.2 down}}
  • Wait for 15 seconds to check for any link failure (error/fault/defect).

© 2025 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks