Initiating Test Message

This article describes the intiation of the test messages.

CLI Configurations

At CUST1

• Initiate a test message from MEP at CUST1 to MEP at CUST3.
  your product# ethernet cfm test mac 00:03:02:03:04:02 domain OP1 vlan 2 count 5

TST to 00:03:02:03:04:02 from 00:01:02:03:04:02 with 33(64) bytes of data.
60 bytes to 00:03:02:03:04:02: seq_no=0
60 bytes to 00:03:02:03:04:02: seq_no=1
60 bytes to 00:03:02:03:04:02: seq_no=2
60 bytes to 00:03:02:03:04:02: seq_no=3
60 bytes to 00:03:02:03:04:02: seq_no=4
--- 00:03:02:03:04:02 test statistics ---
packets sent = 5  with prbs signal without crc32 pattern

SNMP Configurations

At CUST1

• Initiate a test message from MEP at CUST1 to MEP at CUST3. [Index: ContextID = 0, MD-Index = 1, MA-Index = 1, MEP-ID = 10]
  % snmp0 set {{fsMIY1731MepTransmitTstDestType.0.1.1.10 multicast }}
  % snmp0 set {{fsMIY1731MepTransmitTstDestMepId.0.1.1.10 30 }}
  % snmp0 set {{fsMIY1731MepTransmitTstStatus.0.1.1.10 start }}

• Verify whether the test counter in incremented for test messages is sent. [Index: ContextID = 0, MD-Index = 1, MA-Index = 1, MEP-ID = 10]
  % snmp0 get {fsMIY1731MepTstOut.0.1.1.10 }

{1.3.6.1.4.1.29601.2.7.1.2.4.1.58.0.1.1.10 Unsigned32 4}