Enabling IEEE 802.3 Organizationally Specific TLVs
  • 24 Apr 2023
  • 1 Minute to read
  • Contributors
  • PDF

Enabling IEEE 802.3 Organizationally Specific TLVs

  • PDF

Article summary

This section explains how to configure IEEE 802.3 Organizationally Specific TLVs for transmission.


Note: By default, transmission status is set to Disabled.

The following are the basic optional TLVs in LLDP:

  • MAC-PHY Configuration/Status TLV
  • Link Aggregation TLV
  • Max Frame Size TLV


Note: Configure the LLDP module status as Enabled. See Configuring LLDP Module Status.

  1. Enable IEEE 802.3 Organizationally Specific TLVs by executing the following commands.
  • Enter the Global Configuration mode
your product# configure terminal
  • Enable IEEE 802.3 Organizationally Specific TLVs on port P1.
your product(config)# interface gigabitethernet 0/1
your product(config-if)# lldp tlv-select dot3tlv macphy-config link-aggregation max-framesize
  • Exit from the Global Configuration mode.
your product(config)# end
  1. View the local system information by executing the following command.
your product# show lldp local gigabitethernet 0/1
Port Id SubType : Interface Alias
Port Id : Slot0/1
Port Description : Ethernet Interface
Enabled Tx Tlvs : Mac Phy, Link Aggregation, Max Frame Size
Extended 802.3 TLV Info
-MAC PHY Configuration & Status
Auto-Neg Support & Status : Supported, Enabled
Advertised Capability Bits : 6c11
10base-T(HD)
10base-T(FD)
100base-TX(HD)
100base-TX(FD)
Asym and Symm PAUSE(FD)
1000base-T(FD)
Operational MAU Type : 16
-Link Aggregation
Capability & Status : Not Capable, Not In Aggregation
Aggregated Port Id : 1
-Maximum Frame Size : 1500
Extended 802.1 TLV Info
-Port VLAN Id : 1
-Port & Protocol VLAN Id
Protocol VLAN Id Support Protocol VLAN Status TxStatus
---------------- ------- -------------------- --------
0 Supported Enabled Disabled
-Vlan Name
Vlan Id Vlan Name TxStatus
------- --------- --------
1 Disabled
--------------------------------------------------------------------

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.