Disabling IEEE 802.1 Organizationally Specific TLVs
  • 05 Jul 2023
  • 1 Minute to read
  • Contributors
  • PDF

Disabling IEEE 802.1 Organizationally Specific TLVs

  • PDF

Article summary

This section explains how to disable IEEE 802.1 Organizationally Specific TLVs for transmission.


Note: Configure the LLDP module status as Enabled. See Configuring LLDP Module Status.

  1. Configure the VLAN name as vlan1 by executing the following commands.
your product# configure terminal
your product(config)# switch default
your product(config-switch)# vlan 1
your product(config-switch-vlan)# ports gigabitethernet 0/1 name vlan1
your product(config-switch-vlan)# end
  1. Enable all TLVs. See:
    Enabling LLDP Basic Optional TLVs
    Enabling IEEE 802.1 Organizationally Specific TLVs
    Enabling IEEE 802.3 Organizationally Specific TLVs

  2. Disable IEEE 802.1 Organizationally Specific TLVs by executing the following commands.

  • Enter the Global Configuration mode.
your product# configure terminal
  • Disable LLDP IEEE 802.1 Organizationally Specific TLVs.
your product(config)# interface gigabitethernet 0/1
your product(config-if)# no lldp tlv-select dot1tlv port-vlan-id protocol-vlan-id all vlan-name all
  • Exit from the Global Configuration mode.
your product(config)# end
  1. View the local system information by executing the following command.
your product# show lldp local gigabitethernet 0/1
Port Id SubType : Interface Alias
Port Id : Slot0/1
Port Description : Ethernet Interface
Enabled Tx Tlvs : Port Description, System Name,
System Description, System Capability,
Management Address, Mac Phy, Link Aggregation,
Max Frame Size
Extended 802.3 TLV Info
-MAC PHY Configuration & Status
Auto-Neg Support & Status : Not Supported, Disabled
Advertised Capability Bits : 0000
Operational MAU Type : 0
-Link Aggregation
Capability & Status : Not Capable, Not In Aggregation
Aggregated Port Id : 1
-Maximum Frame Size : 1500
Extended 802.1 TLV Info
-Port VLAN Id : 1
-Port & Protocol VLAN Id
Protocol VLAN Id Support Protocol VLAN Status TxStatus
---------------- ------- -------------------- --------
0 Supported Enabled Disabled Output
-Vlan Name
Vlan Id Vlan Name TxStatus
------- --------- --------
1 vlan1 Disabled Output
------------------------------------------------------


Note: Enabled Tx Tlvs do not display any IEEE 802.1 Organizationally Specific TLVs. Port & Protocol VLAN ID, VLAN Name TLVs are disabled because IEEE 802.1 Organizationally Specific TLVs are disabled.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.