This article provides the sample configuration setup for provisioning ZTP.
Configuration and Testing Topologies
ZTP Configuration and Testing Topology
Basic Configuration
This section details the CLI configuration for the ZTP provisioning.
Configuration through CLI
The basic CLI configuration steps are listed below.
- your product# configure terminal
- your product(config)# set beacon advertisment enable
- your product(config)# set beacon advertisment interval 600
- your product(config)# set beacon domain-id-match enable
- your product(config)# set beacon domain-id-value accd
- your product(config)# set use-beacon-rate enable
- your product(config)# int xl-ethernet 0/1
- your product(config-if)# set beacon discovery enable
- your product(config-if)# end
© 2025 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks