Configuring ZTP - Examples
- 31 May 2023
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Configuring ZTP - Examples
- Updated on 31 May 2023
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Article Summary
Share feedback
Thanks for sharing your feedback!
This article provides the sample configuration setup for provisioning ZTP.
Configuration and Testing Topologies
ZTP Configuration and Testing Topology
Basic Configuration
This section details the CLI configuration for the ZTP provisioning.
Configuration through CLI
The basic CLI configuration steps are listed below.
- your product# configure terminal
- your product(config)# set beacon advertisment enable
- your product(config)# set beacon advertisment interval 600
- your product(config)# set beacon domain-id-match enable
- your product(config)# set beacon domain-id-value accd
- your product(config)# set use-beacon-rate enable
- your product(config)# int xl-ethernet 0/1
- your product(config-if)# set beacon discovery enable
- your product(config-if)# end
© 2024 Accedian Networks Inc. All rights reserved. Accedian®, Accedian Networks®, the Accedian logo™, Skylight™, Skylight Interceptor™ and per-packet intel™, are trademarks or registered trademarks of Accedian Networks Inc. To view a list of Accedian trademarks visit: http://accedian.com/legal/trademarks/.
Was this article helpful?
