SFP Configuration
  • 30 Mar 2022
  • 1 Minute to read
  • Contributors
  • PDF

SFP Configuration

  • PDF

Article summary

To change speed manually

  1. Access the page Port ▶SFP ▶Configuration.

  2. Select the desired connector to obtain the detailed dialog: SFP-X Configuration.

  3. Clear the Automatic check box if selected. (This option is selected by default.)
    The three speed options appear.

  4. Select the appropriate option.

  5. Click Apply.

For more information on specific parameters, refer to the following table.

Port ▶SFP ▶Configuration

ParameterDescription
PresentAn indication of whether or not the SFP is present. Available options are:
  • Green: The SFP is present
  • Red: The SFP is not present
ConnectorThe physical connector used by the port
SpeedThe speed supported by the SFP
  • Automatic: Allows the SFP port to operate at the best speed determined via auto-detection. Clear this box to manually select a speed for this SFP.
  • 100 Mbps/1 Gbps: Forces the SFP port to operate at the selected speed.

Note: The available override speeds are dependent on the model.

  • Each optical SFP port can operate at the 100 Mbps supported on all SFP ports.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.