- Print
- PDF
To set up packet loss instances
Access the page SOAM ▶ CFM ▶ Packet Loss ▶ Configuration.
A listing of all existing packet loss instances is displayed.Click Add to create a packet loss instance or click the packet loss instance index to edit an existing packet loss instance.
Complete the required fields, then click Apply.
For more information on specific parameters, refer to the following table.
Packet Loss Configuration (SOAM ▶ CFM ▶ Packet Loss ▶ Configuration)
Parameter | Description |
---|---|
Index | The packet loss instance unique identifier |
PL Name Name | The name of the packet loss instance. |
MEP Index MEP idx | The index assigned to the Maintenance association End Point |
MEPID | The local Maintenance association End Point Identifier |
Remote MEPID R-MEPID | The remote Maintenance association End Point Identifier Note: A peer MEP should have the sequence number enabled to allow a local MEP to perform CCM-based packet loss measurements. |
Priority | The Priority value to be used in VLAN tags, if present, in the transmitted frame. Same as MEP's CCM priority. |
Interval | The Interval between packet loss measurements. This value is inherited from the MA/MEG's CCM interval. |
Enable | Enables packet loss measurements. |
Reference Period | Specify the reference period in minutes. |
Threshold | Specify (as a percentage) the maximum ratio of packets lost allowed before issuing an alarm during the reference period. |
© 2024 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks