- Print
- PDF
Flowmeter is a high frequency bandwidth utilization meter that is available on the following Accedian products:
- Skylight element: FSX
- Skylight element: FS 1G
- Skylight element: FS 10G
- Skylight sensor: control
The Flow configuration step can be used to set up flowmeters on all of these products.
Here are some points that you should be aware of when setting up a configuration step for flowmeter on a Skylight sensor: control:
- A flowmeter is called a port rule. A flowmeter instance is considered a rule and is associated with a port connected to a remote device (Skylight sensor: module or Skylight sensor: SFP compute module).
- Four flowmeters (port rules) can be associated with a port receiving incoming traffic.
- A flowmeter does not have a name. Since a flowmeter is a rule associated with a port, its unique identifier is a port rule number (a value from 1 to 4).
Here are some points that you should be aware of when setting up a configuration step for flowmeter on FS and FSX Skylight elements:
- A flowmeter instance is called a "flow".
- Flow name is the unique identifier for a flow.
- Multiple flows can be associated with a port receiving incoming traffic.
- A metering action can be applied to a flow.
To set up a Flow configuration job
Access the page Commission ▶ Jobs.
Set all common configuration job settings, as described in "Creating Configuration Jobs in GUI Mode" and "Creating Configuration Jobs Using Data Sets".
Select Flow in the left pane. The Flow tab is displayed.
Complete all fields in the Flow tab as required. For more information on parameters, see the table below.
Click Apply, then click Close.
Click the Refresh button to refresh the user interface.
Flow tab (Commission ▶ Jobs)
Flow configuration
Parameter | Description |
---|---|
Enable | Use this checkbox to enable or disable the flowmeter instance. |
Flow name | This parameter is only used on the FSX Skylight element. On the FSX, a flowmeter instance is called a flow. The Flow name is the unique identifier for a flow on the FSX. Enter a name that contains a maximum of 31 alphanumeric characters. Note: If the FSX will include both Layer-2 and IPv4 (Layer-3) filters, it is recommended that flow name includes a prefix that indicates the type of filter it uses. |
Filter type | Select the type of filter to be applied to incoming streams:
|
Filter name | Enter the name of a filter that exists on the system on which flowmeter is being configured. |
Port | The name that identifies the port. |
Port name | Enter the name of a port that exists on the system on which flowmeter is being configured. |
Port rule | This parameter is only used on the Skylight sensor: control. The port rule number is the unique identifier for a flowmeter on the Skylight sensor: control. Enter the number of a port rule that exists on the sensor: control on which flowmeter is being configured. Valid values: 1 to 4 |
Metering action | This parameter is only used on the FSX Skylight element. Select the metering action applied to incoming streams that match the specified filter. Possible values:
|
© 2024 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks