Restoring Factory Default Settings
- 30 Jan 2024
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Restoring Factory Default Settings
- Updated on 30 Jan 2024
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Article Summary
Share feedback
Thanks for sharing your feedback!
You can reset the unit to its factory default settings either by using the button on the panel of the unit or by using the management Web interface. Each way is described below.
Note: Only complete a “HARD RESET” when the management Web interface is not responding properly.
Contact technical support if you require assistance at skylight_tac@cisco.com
CAUTION: Resetting to factory default settings affects current operations.
To reset the unit to factory default settings via the Web interface
Access the page System ▶Maintenance ▶Firmware.
Click the Factory default button.
Click the Reboot button.
To reset the unit to factory default settings from the unit’s front panel
Press and hold the RST button on the front panel.
Keep holding the RST button until the LEDs for Minor, Major, Critical and Power flash at the same time.
Release the RST button.
© 2024 Accedian Networks Inc. All rights reserved. Accedian®, Accedian Networks®, the Accedian logo™, Skylight™, Skylight Interceptor™ and per-packet intel™, are trademarks or registered trademarks of Accedian Networks Inc. To view a list of Accedian trademarks visit: http://accedian.com/legal/trademarks/.
Was this article helpful?
