Redundancy Commands – CLI Help and Command Summary
  • 21 Jun 2024
  • 1 Minute to read
  • Contributors
  • PDF

Redundancy Commands – CLI Help and Command Summary

  • PDF

Article summary

Tab-completion help is available for the redundancy commands on the Skylight orchestrator command line.

The following tables of redundancy commands list all the parameters and possible parameter values.

redundancy config

ParametersPossible parameter values
auto-failoverenable, disable
monitor-portdefault
preferrednone, site-a, site-b
replication-port
site-ahostname of appliance at Site-A
site-bhostname of appliance at Site-B

redundancy config virtual-ip

ParametersPossible parameter values
vip-addressIP address used as single point of access to Skylight orchestrator system
vip-primary-interfaceAny interface defined for the virtual IP address. Default: eth0
vip-stateenable, disable

redundancy control

ParametersPossible parameter values
restart--
resume--
set-preferred-sitenone (default), site-a, site-b
start--
stop--
suspend--
switch--
handle-split-brain--

redundancy license

ParametersPossible parameter values
importfullPath/licenseFilename
reset--

redundancy show

ParametersPossible parameter values
configuration--
statistics--
status--

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.