- Print
- DarkLight
- PDF
This article describes the creation and configuration of interfaces at CUST1, CUST2, and CUST3.
CLI Configurations
At CUST1, CUST2, and CUST3
- Enable interfaces
your product# configure terminal
your product(config)# interface gigabitethernet 0/1
your productiss(config-if)# exit
your product(config)# interface gigabitethernet 0/2
your product(config-if)# no shutdown
your product(config-if)# exit
your product(config)# interface gigabitethernet 0/3
your product(config-if)# no shutdown
your product(config-if)# exit
SNMP Configurations
At CUST1, CUST2, and CUST3
- Enable interfaces
[Index: Interface Number = 1]
% snmp0 set {{ifMainAdminStatus.1 up }}
% snmp0 set {{fsVcId.1 0 }}
% snmp0 set {{fsVcIfRowStatus.1 active }}
[Index: Interface Number = 2]
% snmp0 set {{ifMainAdminStatus.2 up }}
% snmp0 set {{fsVcId.2 0 }}
% snmp0 set {{fsVcIfRowStatus.2 active }}
[Index: Interface Number = 3]
% snmp0 set {{ifMainAdminStatus.3 up }}
% snmp0 set {{fsVcId.3 0}}
% snmp0 set {{fsVcIfRowStatus.3 active }}
© 2024 Accedian Networks Inc. All rights reserved. Accedian®, Accedian Networks®, the Accedian logo™, Skylight™, Skylight Interceptor™ and per-packet intel™, are trademarks or registered trademarks of Accedian Networks Inc. To view a list of Accedian trademarks visit: http://accedian.com/legal/trademarks/.