Configuring MEF 10.2 Coupled Color Aware
  • 10 Jul 2024
  • 1 Minute to read
  • Contributors
  • PDF

Configuring MEF 10.2 Coupled Color Aware

  • PDF

Article summary

To configure MEF 10.2 coupled color aware

  1. Follow configurations steps 1 through 7 from the article Configuring trTCM Color Blind Mode.

  2. Configure MEF coupled color-blind metering.

configure terminal
meter 1
meter-type mefCoupled color-mode aware cir 1048576 cbs 16777216 eir 2097152 ebs 33554432  
end
  1. Configure coupled QOS color-aware metering actions.
configure terminal
policy-map 10
set meter 1 exceed-action cos-transmit-set 5 violate-action cos-transmit-set 5
set policy class 10 default-priority-type none
end
configure terminal
set meter-st enable meter-id 1
end


Notes:

In MEF 10.2 coupled color aware mode, Green packet remarking is not supported (the configuration of green remarking priority values is not applicable, when metering entry is color aware) and only yellow, red packets remarking are supported​.

Red packet remarking should be configured the same as yellow or drop.



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.