Configuring Traffic
- 07 Apr 2022
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Configuring Traffic
- Updated on 07 Apr 2022
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Article Summary
Share feedback
Thanks for sharing your feedback!
Setting the Working Rate
You must select the layer (Layer 1 or Layer 2) used by the Skylight sensor: control to determine the rate for the traffic generators and traffic regulators. For example, if you set up a traffic generator flow with a bit rate of 20,000 kbps, the remote device must be informed of whic bytes are being used to calculate the bit rate. The working rate options are:
- Layer-1: Rate calculation is based on the Layer-1 frames sizes, including the size of the Inter-Frame Gap (IFG), Preamble and Start-Frame Delimiter (SFD)
- Layer-2: Rate calculation is based on the Layer-2 frames sizes, which does not include the size of the Inter-Frame Gap (IFG), Preamble or Start Frame Delimiter (SFD)
Note: Exercise caution when setting up the working rate. You should ensure that you set the different working rates to the same layer when they work together in a particular setup in order to generate accurate test results.
To set the working rate
Access the page Traffic ▶ Configuration.
Select the working rate to be applied to all entities, then click Apply.
For more information on specific parameters, refer to the following table.
Traffic Configuration (Traffic ▶ Configuration)
| Parameters | Description |
|---|---|
| Generator working rate Regulator working rate | The layer used by the Skylight sensor: control to determine the working rate for the RFC-2544 generator and testsuite as well as for all bandwidth regulators:
|
© 2024 Accedian Networks Inc. All rights reserved. Accedian®, Accedian Networks®, the Accedian logo™, Skylight™, Skylight Interceptor™ and per-packet intel™, are trademarks or registered trademarks of Accedian Networks Inc. To view a list of Accedian trademarks visit: http://accedian.com/legal/trademarks/.
Was this article helpful?
