Creating Network Partition Configuration in GUI Mode
  • 21 Jun 2024
  • 1 Minute to read
  • Contributors
  • PDF

Creating Network Partition Configuration in GUI Mode

  • PDF

Article summary

The following procedure explains how to create a network partition configuration in GUI mode.

To create a network partition configuration in GUI mode

  1. Access the Network Partitions page.

  2. Click the Add partition image.png button.

The Network partition configuration window is displayed. The Users tab is above.
Creating Network Partition Configuration in GUI Mode_1.png

  1. Enter a Partition name.

  2. Drag the users that you want to assign to a partition from the left pane to the right pane titled Users to be added.

  3. If you do not want to select target devices immediately, click Apply then Close to close the window. The new partition is added to the list.

  4. Select the target devices:
    Drag the devices from the left pane (Device selection) to the right pane (Target devices).

  5. Click Apply.

  6. Click Close to close the Network Partitions Configuration window.

  7. Click the Refresh image.pngbutton to refresh the user interface.

Network Partition Configuration (Network Partitions ▶ Add partitions button)

ParameterDescription
Partition nameName of the partition

Users tab

ParameterDescription
NameThe list of user name

Device selection, Elements tab

ParameterDescription
NameIdentifiers for the devices available for selection. Drag devices into the Target devices list.
LabelUser-defined label that will allow users to identify and group modules.
Serial numberThe serial number of the device.
IPThe IP address of the device.
MAC addressThe MAC address of the device.
VersionThe current firmware version that runs the device.
ModelThe model of the device.
Target devicesThe list of devices selected for one of the user's assigned partitions.

© 2024 Cisco and/or its affiliates. All rights reserved.
 
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms

For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks



Was this article helpful?

Changing your password will log you out immediately. Use the new password to log back in.
First name must have atleast 2 characters. Numbers and special characters are not allowed.
Last name must have atleast 1 characters. Numbers and special characters are not allowed.
Enter a valid email
Enter a valid password
Your profile has been successfully updated.