.svg?sv=2022-11-02&spr=https&st=2024-12-23T01%3A15%3A21Z&se=2024-12-23T01%3A25%3A21Z&sr=c&sp=r&sig=1kEFYTPy5IbPwmaeYFnbFF9mKNWgknTwSsY0Y3QQ%2Bm0%3D){kind=logo}
Configuring IPv4 Settings
- 23 Jan 2024
- 1 Minute to read
- Contributors
- Print
- PDF
Configuring IPv4 Settings
- Updated on 23 Jan 2024
- 1 Minute to read
- Contributors
- Print
- PDF
Article summary
Did you find this summary helpful?
Thank you for your feedback
Setting the IGMP Version
Internet Group Management Protocol (IGMP) is a Layer-3 communication protocol used by networking equipment to more efficiently manage multicast traffic. You must select the unit’s IGMP version that applies to all interfaces of the unit.
To set the unit's IGMP version
Access the page System ▶IPv4.
Make a selection from the IGMP Version drop-down list, then click Apply.
For more information on specific parameters, refer to the following table.
IPv4 Settings (System ▶IPv4)
| Parameter | Description |
|---|---|
| Enable Forwarding | Select this box to enable the IPv4 forwarding feature on a per-interface basis. You must now enable forwarding in the System ▶ Configuration ▶Interface page for each IPv4 interface on which you want to forward ingress traffic. If you clear this box, IPv4 forwarding on all interfaces configured on this unit will be automatically disabled. |
| Allow ICMP redirect | Select this box to enable or disable the global ICMP redirects. |
| IGMP Version | Possible values are:
|
© 2024 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and tradmarks
Was this article helpful?