Configuring ECFM on Provider Bridges

The following articles describe the configuration of the ECFM functionality for provider bridges on the following sample topology. Configuration of ECFM on Provider bridges MAC Address of ports on the bridges is of form 00:0m:02:03:04:0n, w...

This article describes the configuration of bridge mode for the bridges. CLI Configurations At Switch1 and Switch5 Set the bridge-mode as customer and spanning tree mode as mst. your product#configure terminal your product(config)# shut...

This article describes the configuration of interfaces on the bridges. CLI Configurations At Switch1, Switch2, Switch5 and Switch6 Create interfaces as up. your product(config)# interface gigabitethernet 0/2 your product(config-if)#...

This article describes the configuration of VLAN on switches. CLI Configurations At Switch1 and Switch5 Create the VLAN 2. your product(config)# vlan 2 Make interfaces as member ports of this VLAN. your product(config-vlan)#...

This article describes the configuration of interface types and mapping of VLAN. CLI Configurations At Switch2 Set the interface as CustomerEdgePort. your product(config)# interface gigabitethernet 0/2 your product(config-if)# bri...

This article describes the enabling of ECFM, MIP CCM database, and traceroute caching. CLI Configurations At Switch1, Switch2, Switch3, Switch4, Switch5, Switch6, Switch7, Switch8 Enable ECFM. your product(config) # ethernet cfm ena...

This article describes the configuration of MD, MA, and MEPs on the switches. CLI Configurations At Switch1 Configure the Maintenance Domain, Service and MEP List . your product(config)# ethernet cfm domain name OP7 level 7 you...

This article describes how to verify the configured MD, MA, and MEPs. CLI Configurations At Switch1 Display the details of all the MEPs and MIPs. your product# show ethernet cfm maintenance-point local --------------------------------...

This article describes the configuration of interface P2 to raise a defect/fault in sample topology. CLI Configurations At Switch5 Make interface P2 as down. your product(config)# interface gigabitethernet 0/2 your product(config-if)#...

This article describes the verification of generated CCM errors. CLI Configurations At Switch1 Display the logged CFM continuity check error conditions. your product# show ethernet cfm errors MEP-ID : 1 Level VLAN RMEP-ID Current d...

This article describes the initiation of loop back and link trace messages to verify and isolate a fault. CLI Configurations At Switch1 Initiate Traceroute to isolate any link failure (error/fault/defect). your product# traceroute eth...

This article describes the configuration of the interface. CLI Configurations At Switch5 Make interface P2 as up your product(config)# interface gigabitethernet 0/2 your product(config-if)# no shutdown SNMP Configurations At Sw...

This article describes how to enable Y.1731. CLI Configurations At Switch1, Switch2, Switch3, Switch5, Switch6, and Switch7 Enable the Y.1731 status. your product(config)# ethernet cfm y1731 enable SNMP Configurations At Switch...

This article describes how to enable the Alarm Indication Signal ( AIS ) and Locked ( LCK ) features. CLI Configurations At Switch6 Verify CCM errors your product# show ethernet cfm errors Shows no link failure, as no error is det...