Configuring ECFM on Customer Bridges

The following articles describe the configuration of the ECFM functionality on the following sample topology. Configuration of ECFM on Customer Bridges The MAC Address of ports on the bridges is of form 00:0m:02:03:04:0n, where m is the bri...

This article describes the creation and configuration of interfaces at CUST1, CUST2, and CUST3. CLI Configurations At CUST1, CUST2, and CUST3 Enable interfaces your product# configure terminal your product(config)# interface gigabitet...

This article describes the creation of VLAN on bridges (CUST1, CUST2, and CUST3) and assigning of member ports for the created VLAN. CLI Configurations At CUST1, CUST2, and CUST3 Create VLAN and assign member ports for this VLAN your pro...

This article describes the enabling of ECFM, traceroute caching, and MIP CCM database on bridges (CUST1, CUST2, and CUST3). CLI Configurations At CUST1, CUST2, and CUST3 Enable ECFM your product(config) # ethernet cfm enable Enable Tr...

This article describes the enabling of the CCM transmission on bridges CUST1 and CUST3. CLI Configurations At CUST1 and CUST3 Enable CCM transmission your product# configure terminal your product(config)# ethernet cfm cc enable level ...

This article describes the generation of CCM errors. Interface P2 of CUST3 is made down to raise a defect/fault in the sample topology. CLI Configurations At CUST3 Make interface P2 down. your product(config)# interface gigabitethern...

This article describes the verification and isolation of a fault using loopback and link trace messages. CLI Configurations At CUST1 Initiate the Loopback transaction from CUST1 to MEP at CUST3 to verify the link failure, where CUST3 MEP’s...

This article describes the configuration of the interface. CLI Configurations At CUST3 Make interface P2 of CUST3 as up. your product(config)# interface gigabitethernet 0/2 your product(config-if)# no shutdown Wait for 5 seco...

This article describes how to enable Y.1731. CLI Configurations At CUST1, CUST2, and CUST3 Enable Y.1731. your product# configure terminal your product(config) # ethernet cfm y1731 enable your product(config) # exit SNMP Con...

This article describes the intiation of frame delay measurement. CLI Configurations At CUST1 Initiate a two-way frame delay measurement from MEP at CUST1 to MEP at CUST3. your product# ethernet cfm frame delay start type two-way level ...

This article describes the intiation of frame loss measurement. CLI Configurations At CUST1 Initiate a frame loss measurement from MEP at CUST1 to MEP at CUST3. your product# ethernet cfm frame loss level 5 vlan 2 mac 00:03:0...

This article describes the intiation of the test messages. CLI Configurations At CUST1 Initiate a test message from MEP at CUST1 to MEP at CUST3. your product# ethernet cfm test mac 00:03:02:03:04:02 domain OP1 vlan 2 count ...

This article describes the initiation of Availability Measurement. CLI Configurations At CUST1 Initiate an availability measurement from MEP at CUST1 to MEP at CUST3. your product# ethernet cfm availability measure start level 5 vl...