fault-propagation edit
fault-propagation edit - Modify port fault propagation options.
Description:
The Sensor Control supports the Fault Propagation operation in One-Way Link mode or One-Way EVC mode only.
When Fault Propagation is enabled for a port in One-Way Link mode, its link status (up or down) depends on the opposite port status.
When Fault Propagation is enabled for a port in One-Way EVC mode, its link status (up or down) depends on ETH-CSF status.
Syntax:
fault-propagation edit <NNI | UNI> {
{state <enable | disable> }
{mode <evc | link> }
{fp-port <NNI | UNI> }}+
Parameters:
| Parameter | Description |
|---|---|
| <NNI | UNI> | Port to which these options apply. |
| state | Enable or disable fault propagation for the specified port. |
| mode | Fault propagation operation mode. Support One-Way Link mode and One-Way EVC mode. |
| fp-port | Port from which the fault is to be propagated. {<NNI | UNI>} |
fault-propagation show
fault-propagation show - Show fault propagation configuration.
Description:
Show fault propagation configuration.
Syntax:
fault-propagation show [<NNI | UNI>]
© 2026 Cisco and/or its affiliates. All rights reserved.
For more information about trademarks, please visit: Cisco trademarks
For more information about legal terms, please visit: Cisco legal terms
For legal information about Accedian Skylight products, please visit: Accedian legal terms and trademarks